Single Cell Horizontal Board End Connectors

Single Cell Horizontal Board End Connectors

Single Twin FAKRA Horizontal Board End Connectors Non-Waterproof, Wave Solderable

Single Cell Horizontal Board End Connectors are connectors used to connect individual cells (units) on a horizontal board. They are typically used to build battery packs or battery modules to achieve higher voltage or capacity requirements.

These connectors are designed to connect the positive and negative terminals of a battery to a battery management system or other device. They typically have two sockets, one for the positive terminal and the other for the negative terminal. The sockets usually have standard electrical interfaces such as metal pins or wire slots to allow for easy connection of wires or other connectors.

Single Cell Horizontal Board End Connectors are typically made of high temperature and corrosion resistant materials to ensure their reliability and long life in battery systems. These connectors may also be shielded to prevent short circuits or other battery failures.

The use of Single Cell Horizontal Board End Connectors simplifies the process of assembling and connecting batteries, increasing the reliability and maintainability of battery systems. They are suitable for a variety of applications, including electric vehicles, solar systems, energy storage systems, and more.

1、Basic Introduction
1.1 Performance parameters of FAKRA connectors
According to the parameter requirements in IS0 20860.
Main electrical performance parameters: transmission frequency 0 ~ 4GHz; characteristic impedance of 50 ohms; maximum load current 1A
Main mechanical performance parameters: latch retention force ≥ 100N error-proof force ≥ 40N

1.2 Common Applications
Wireless signal transmission: vehicle AM/FM; GPS; car networking (2~4GHz, including transmission); remote control.
Video signal transmission applications: ADAS-based outbreak, mainly applied to cameras.

1.3 Relevant Standards
Design standard: ISO20860; USCAR18
Verification standards: LV214; USCAR2; USCAR17

1.4 Adaptive Cables
Commonly used cable models: RG 174; RTK 031; RG59; RG179; RG58

1.5 Waterproofing
With the waterproof version of the harness end connector, an IPX7/IPX9K waterproof rating can be achieved at the connector pair mating interface.

2、FAKRA connector structure
2.1 The overall structure of board-end and harness-end connectors
A common FAKRA connector consists of a plastic shell, an outer conductor, a centre conductor, an insulator, a crimp sleeve (harness end connector only) and a secondary lock (harness end connector only).

2.2 Secondary lock, colour + mechanical error protection
Secondary Lock: Ensures that the terminal is mounted in place and increases the retention of the terminal. The secondary lock is usually purple.
Colour + Mechanical Misalignment Prevention: There are structures designed to prevent misalignment at the mating interface of the connector, with different coloured plastic shells for different misalignment prevention structures.

Electrical Characteristics

Mechanical Property

Antenna Communication Application.
RF signals are widely used in vehicle wireless communication system, RF signal transmission connector can bring more data, higher transmission frequency and more stable signal transmission quality so as to bring better driving experience to customers.
Zhuoyuexin FAKRA connector's excellent electrical, mechanical and environmental properties enable it to be widely used in automotive antenna fields such as AMIFM, GPS, Bluetooth, in-car Internet, remote control and keyless access.

Other Hot Products:

Automotive Antennas
RF Coaxial Cable Connectors
Cable Assembly
Pcb Connectors